P1193high severityPowertrain
Inline High Pressure Pump Fault
on 2014 Jeep Cherokee 3.2L V6 · AWD
What this code means
The PCM has detected a fault with the inline high-pressure fuel pump. The fuel pump is not delivering the commanded fuel pressure, which can cause starting problems and reduced engine performance. Common on Chrysler GDI engines.
Symptoms
- Check Engine Light
- Hard starting or extended crank time
- Rough idle
- Loss of power under acceleration
- Engine stalling
Common causes
- Failing high-pressure fuel pump
- Clogged fuel filter restricting flow
- Fuel pump relay failure
- Wiring or connector issue at fuel pump
- Low voltage supply to fuel pump module
Diagnostic steps
- Check fuel pressure with a gauge at the fuel rail
- Monitor fuel pressure PID on scan tool during cranking and at idle
- Inspect fuel pump relay and fuse
- Test fuel pump voltage supply
- Check fuel filter for restriction
Repair notes
Replace the high-pressure fuel pump if pressure is below specification; check fuel filter and wiring first.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1