P2104critical severityPowertrain
Throttle Actuator Control System Forced Idle
on 2014 Jeep Cherokee 3.2L V6 · AWD
What this code means
ECM has forced the engine to idle speed only due to a detected throttle control fault.
Symptoms
- Engine stuck at idle
- Check engine light
- Vehicle barely moves
- Traction control light on
Common causes
- Throttle body failure
- APP sensor fault
- Wiring issue
- ECM detected conflicting throttle signals
Diagnostic steps
- Scan for other DTCs
- Check APP sensor signals
- Inspect throttle body
- Clear codes and test
Repair notes
Diagnose root cause from accompanying DTCs. This is a protective measure.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1