P3015moderate severityPowertrain
Intake Valve Control Solenoid Circuit Intermittent Bank 1
on 2014 Jeep Cherokee 3.2L V6 · AWD
What this code means
The intake valve control solenoid on Bank 1 has an intermittent electrical fault. Continuous VVT systems use this solenoid to control cam phasing oil flow.
Symptoms
- Check Engine Light comes and goes
- Intermittent rough idle
- Sporadic power loss
- Variable valve noise
- Inconsistent fuel economy
Common causes
- Loose solenoid connector
- Wiring chafing against engine
- Solenoid internal intermittent failure
- Thermal expansion causing contact loss
- Corroded pins
Diagnostic steps
- Monitor VVT solenoid command vs cam position
- Wiggle test on solenoid connector
- Inspect wiring harness routing
- Check connector pin tension
- Test solenoid at operating temperature
Repair notes
Repair connector or replace VVT solenoid. Re-route wiring away from heat sources.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1