C0325low severityChassis
Ride Height Sensor Calibration Required
on 2019 Jeep Cherokee 3.2L V6 · AWD
What this code means
One or more ride height sensors require calibration after service or replacement.
Symptoms
- Suspension warning light
- Incorrect ride height all corners
- Vehicle rides too high or too low
- Ride height asymmetric
Common causes
- Sensor replaced without calibration
- Suspension component service
- Module replacement
- Battery disconnect on some vehicles
Diagnostic steps
- Perform ride height sensor calibration with scan tool
- Verify vehicle is on level ground with correct tire pressure
- Check that all sensors are reading plausible values
- Confirm calibration procedure completed successfully
Repair notes
Perform ride height calibration on level surface with correct tire pressures and no load.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld (~$40)
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
Pro diagnostics (~$1,500+)
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0025
LF Wheel Speed Sensor Circuit Intermittent