P0645low severityPowertrain
A/C Clutch Relay Control Circuit
on 2013 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The PCM detected a fault in the air conditioning compressor clutch relay control circuit. This can prevent the A/C compressor from engaging properly.
Symptoms
- A/C not blowing cold
- A/C compressor won't engage
- Check engine light on
Common causes
- Faulty A/C clutch relay
- Wiring or connector damage
- Corroded relay contacts
- Failed PCM driver circuit
Diagnostic steps
- Scan for stored codes
- Inspect A/C clutch relay and connector
- Test relay coil and control circuit voltage
- Check PCM output signal
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0005
Fuel Shutoff Valve A Control Circuit/Open
P0006
Fuel Shutoff Valve A Control Circuit Low
P0007
Fuel Shutoff Valve A Control Circuit High
P0008
Engine Position System Performance - Bank 1
P0009
Engine Position System Performance - Bank 2
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1