P1596moderate severityPowertrain
Speed Control Switch Always High
on 2017 Jeep Wrangler 3.6L V6 · 4WD
What this code means
The PCM detected the speed control switch signal is stuck in a high voltage state. This is a Chrysler-specific code with no direct OBD-II generic equivalent.
Symptoms
- Cruise control inoperative
- Check engine light on
- Cruise engages unexpectedly
Common causes
- Stuck speed control switch
- Wiring shorted to voltage
- Bad connector
- Faulty PCM
Diagnostic steps
- Scan for stored codes
- Test speed control switch voltages
- Inspect wiring for short to power
- Check connector integrity
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1