Free API

1990 MITSUBISHI ECLIPSE

1.8L I4FWDAUTOMATICgas
Be the first sponsor for this vehicle

For $99, we generate the full set of step-by-step repair procedures for this exact vehicle. Free for everyone, forever, with your name on every one.

Sponsor — $99
Dead battery / stuck in Park? Emergency neutral procedure for this Eclipse
5-Year Cost of Ownership
$30,875 maintenance + known platform issues
~$6,175/yr · 510¢/mile equivalent · $6,389 maintenance + $6,536 expected platform issues
Compare this engine
vs
2.4L I4
vs
3.8L V6

Common Problems & Known Issues

The first-gen Eclipse (1990-1994 platform) is a fun DSM chassis built alongside the Talon and Laser, sharing components and weaknesses. The 4G37 1.8L is gutless but reliable; the 4G63 2.0L turbo is a tuner favorite but notorious for crankwalk and oiling issues when abused or poorly maintained.

Crankshaft Thrust Bearing Failure ("Crankwalk") — 4G63 Turbo

Common · high severity
Typical onset: 80,000-150,000 mi
Symptoms: Metallic grinding or knocking from bottom end, especially when clutch is depressed, Clutch engagement point changes over time (pedal feel shifts), Excessive end-play detected with dial gauge on crank pulley, Eventually: catastrophic bottom-end failure, oil starvation, rod knock
Fix: Engine teardown and crankshaft replacement; usually go with a forged crank and ACL race bearings while you're in there. 16-24 labor hours depending on whether you pull the engine. Often triggers a full rebuild since you're already apart.
Estimated cost: $3,500-6,500

Automatic Transmission Failure (F4A33 / KM177)

Common · high severity
Typical onset: 90,000-130,000 mi
Symptoms: Slipping between gears, especially 2nd-3rd shift, Burnt ATF smell, dark or metallic fluid, Delayed or harsh engagement from Park to Drive, Complete loss of forward gears; limp mode or stuck in 2nd
Fix: The F4A33 auto is fragile, especially behind the turbo. Rebuild kits exist but most shops recommend used/reman unit swap due to age of vehicle. 8-12 hours labor for R&R plus rebuild or replacement unit cost.
Estimated cost: $1,800-3,200

Head Gasket Failure — 4G63 Turbo

Occasional · high severity
Typical onset: 100,000-140,000 mi
Symptoms: White smoke from exhaust, especially on cold start, Coolant loss with no visible leaks; bubbles in overflow tank, Overheating under boost or highway driving, Oil-in-coolant or coolant-in-oil (milky dipstick or cap)
Fix: Multi-layer steel (MLS) gasket and ARP head studs are the correct fix; OEM composite gaskets fail again. Requires head resurfacing. 10-14 hours labor. Check for warped head; budget for machine work.
Estimated cost: $1,500-2,800

Transmission and Engine Mount Deterioration

Common · medium severity
Typical onset: 70,000-110,000 mi
Symptoms: Excessive drivetrain clunk on throttle lift or engagement, Shifter slop, hard to find gears (manual), Vibration at idle, especially with A/C on, Engine rocks visibly under hard acceleration
Fix: Replace all engine/trans mounts as a set; OEM rubber is long gone by now. Polyurethane aftermarket mounts are stiffer but last. 3-5 hours labor for full set (front, rear, trans, passenger side).
Estimated cost: $400-750

Fuel Pump and Filter Clogging

Occasional · medium severity
Typical onset: 80,000-120,000 mi
Symptoms: Fuel starvation under boost or high-speed pulls, Engine stumbles or cuts out above 4,500 RPM, Long crank times, hard starting when hot, Lean AFR readings, potential detonation on boosted cars
Fix: In-tank pump replacement and inline filter change. Pump access is easier on AWD models (hatch removal); FWD requires tank drop. 2-4 hours labor. Use OEM or Walbro 255 if modded.
Estimated cost: $350-650

Electrical Wiring Harness Degradation

Occasional · medium severity
Symptoms: Intermittent no-start, no crank, Gauges flicker or drop out; tach stops working, Radiator fan stays on or won't turn on, Check Engine Light with MAF, TPS, or O2 sensor codes that don't resolve with part replacement
Fix: Early 90s Mitsubishi wiring insulation gets brittle. Common failure points: engine harness near exhaust manifold, chassis grounds, ECU connector pins. Diagnosis can eat hours; repair is trace-and-splice or harness replacement. 4-8 hours labor depending on extent.
Estimated cost: $400-1,200

Pop-Up Headlight Pivot Gear Failure

Occasional · low severity
Symptoms: One or both headlights won't pop up or retract fully, Grinding noise from headlight motors, Lights stuck in up or down position, Manual crank still works but motor doesn't
Fix: Plastic pivot gears strip over time; replacement gears available aftermarket. Motor removal and reinstall per side. 1-2 hours labor per light assembly.
Estimated cost: $150-300
Owner tips
  • If buying a 4G63 turbo car, pull the valve cover and inspect cam lobes for scoring; these engines were often beat on and starved of oil changes.
  • Check crank end-play immediately on purchase (max spec 0.004-0.008 in); if over 0.012 in, budget for a motor rebuild soon.
  • Upgrade to an MLS head gasket and ARP studs preventively if you plan to keep the car or run more than 15 psi boost.
  • Replace all coolant hoses and t-stat housing; 30+ year old rubber is guaranteed to let you down at the worst time.
  • Manual trans cars are far more reliable than autos; if shopping, strongly favor the 5-speed.
Buy a manual trans car with service records and low owner count; avoid automatics and any turbo car with unknown maintenance history — you're looking at a $4k-6k engine rebuild lottery ticket.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.

Labor Times — 1990 Mitsubishi Eclipse

502 jobs across 17 categories

body (31)

brakes (41)

cooling (21)

drivetrain (24)

electrical (74)

engine (64)

exhaust (24)

hvac (23)

interior (24)

maintenance (30)

steering (19)

suspension (42)

transmission (44)

🔧 Built by master technician Chris Hackleman · Master Technician · 20+ years.
Stuck on a repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →