1987 NISSAN MAXIMA

3.0L V6RWDAUTOMATICgas
5-Year Cost of Ownership
$53,445 maintenance + known platform issues
~$10,689/yr · 890¢/mile equivalent · $32,383 maintenance + $3,862 expected platform issues
Compare this engine
vs
3.5L V6 VQ35DE
Common Problems & Known Issues

The 1987 Maxima (VG30E V6 primarily, some 2.4L carryovers) is known for durable powertrains but suffers from age-related sealing issues, cooling system neglect consequences, and characteristic VG-series timing chain wear that can become catastrophic if ignored.

VG30E Timing Chain Stretch and Guide Failure

Common · high severity
Typical onset: 120,000-180,000 mi
Symptoms: rattling/slapping noise from front of engine on cold start, noise quiets after 10-15 seconds as oil pressure builds, eventually becomes constant rattling, check engine light with timing-related codes if equipped
Fix: Front cover removal, timing chain set replacement including guides, tensioners, and oil pump drive chain. 8-12 hours labor depending on AC/power steering bracket complications. Critical to replace all guides—plastic deteriorates with age even at lower miles on neglected oil changes.
Estimated cost: $1,200-2,200

Head Gasket Failure from Overheating

Occasional · high severity
Typical onset: 100,000-150,000 mi
Symptoms: white smoke from exhaust, coolant loss with no visible leaks, milky oil on dipstick or cap, overheating episodes, rough idle or misfires
Fix: Head removal, surface milling typically required (VG30E heads warp easily), new gasket set, timing components inspection while apart. 14-18 hours labor. Often discovered after radiator or water pump failure was ignored too long.
Estimated cost: $1,800-3,200

Valve Cover Gasket and Camshaft Seal Leaks

Common · low severity
Typical onset: 80,000-120,000 mi
Symptoms: oil pooling on top of exhaust manifolds, burning oil smell, oil drips under front of engine, visible oil seepage around valve covers
Fix: Valve cover gasket replacement both sides, camshaft seals while accessible, clean mating surfaces thoroughly. 3-4 hours labor. Use OEM-quality gaskets—cheap aftermarket sets leak again within 6 months on these engines.
Estimated cost: $400-700

Automatic Transmission Slipping (Jatco 4-Speed)

Occasional · high severity
Typical onset: 130,000-180,000 mi
Symptoms: delayed engagement into drive or reverse, slipping between 2nd and 3rd gear under load, flare-ups during shifts, burnt transmission fluid smell
Fix: Jatco E4N71B transmission rebuild or replacement. Internal clutch pack wear, worn bands. 12-16 hours for R&R and rebuild. These transmissions are robust IF serviced every 30k—most haven't been. Used replacements from junkyard are gambles.
Estimated cost: $1,800-3,000

Fuel Injector Seal Deterioration and Leaking

Occasional · medium severity
Typical onset: 90,000-140,000 mi
Symptoms: fuel smell in engine bay especially when hot, hard starting when engine is warm, rough idle, visible fuel seepage at injector bases, fire risk if severe
Fix: Remove fuel rail, replace all injector o-rings and seals, clean injectors while out. 2-3 hours labor. Age and heat cycles harden the rubber—original seals are 35+ years old now. Always do all six at once on V6.
Estimated cost: $300-550

Radiator Core Corrosion and Plastic Tank Cracking

Common · medium severity
Typical onset: 60,000-100,000 mi
Symptoms: coolant leaking from radiator seams or tanks, overheating in traffic or at idle, visible green stains on radiator face, low coolant warning if equipped
Fix: Radiator replacement, system flush, new hoses recommended at same time (they're the same age). 2-3 hours labor. Original radiators are long past service life—plastic becomes brittle. Do NOT ignore even small leaks; VG30E does not tolerate overheating.
Estimated cost: $350-650

Front Strut Mount Bearing Failure

Occasional · low severity
Typical onset: 80,000-120,000 mi
Symptoms: clunking over bumps, steering wheel doesn't return to center smoothly, creaking noise when turning steering at standstill, uneven tire wear on front
Fix: Strut mount and bearing replacement both sides. 2-3 hours labor. While in there, inspect struts themselves—originals are beyond shot. Common to do full strut assemblies at this age rather than just mounts.
Estimated cost: $400-800
Owner tips
  • Change oil every 3,000 miles religiously—VG30E timing chains are oil-change-interval sensitive; extended intervals kill guides prematurely
  • Inspect and replace coolant every 2 years—this engine warps heads easily and overheating events are expensive
  • If buying used, listen for timing chain rattle on COLD start; if present, budget $1,500-2,000 immediately
  • These cars respond well to preventive maintenance but punish neglect disproportionately—get service records or walk away
Solid platform if timing chain and cooling system are addressed proactively, but most survivors have been neglected; buy only with proof of recent timing work or budget for it immediately.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
591 jobs across 17 categories
Building an app?
Free API access to all this data — 50 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included. Built by the same team.
Try ShopBase →