Fitment notes: AWD models may require AGM battery due to increased electrical demands and start-stop system
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Every control module on the 2021-2026 Nissan Rogue — where it lives, replacement time, and what it takes to program a replacement. Modules marked dealer / factory tool won't work after a part swap alone — budget for programming.
Transmission Control Module (TCM)4.5 hr R&Rdealer / factory tool +1.0 hrCVT transmission (standard on all automatic models)▸ programming details
📍 CVT: integrated into CVT valve body inside transmission. Manual: not applicable
🔧 CONSULT-III Plus with NTIS subscription
⚠️ Requires transmission fluid drain and valve body removal. VIN programming and adaptive value initialization required. CVT fluid refill and relearn procedure adds 0.5 hours. 2021+ uses updated CVT8 transmission.
Electric Power Steering Control Module (EPS)2.5 hr R&Raftermarket tool +0.5 hr▸ programming details
📍 Integrated into electric power steering column assembly, below instrument panel at steering column
🔧 CONSULT-III Plus or Autel MaxiSys
⚠️ Typically replaced as assembly with steering column motor. Steering angle sensor calibration and zero-point learning required after replacement.
Anti-lock Brake System Control Module (ABS)1.8 hr R&Raftermarket tool +0.3 hr▸ programming details
📍 Engine compartment, driver side inner fender, mounted to ABS hydraulic unit
🔧 CONSULT-III Plus or Autel/Launch aftermarket tools
⚠️ Integrated with hydraulic unit; module alone can be replaced without bleeding if careful. Brake bleeding recommended. Basic configuration and wheel sensor calibration required.
Body Control Module (BCM)1.5 hr R&Rdealer / factory tool +1.0 hr▸ programming details
⚠️ Controls lighting, wipers, door locks, power windows. VIN programming and configuration required. Intelligent Key registration must be performed after replacement. 2021+ has expanded feature set.
Around View Monitor Control Module (AVM)1.5 hr R&Rdealer / factory tool +0.8 hrSL and Platinum with Around View Monitor (360-degree camera)▸ programming details
📍 Behind instrument panel, center, near AVN unit
🔧 CONSULT-III Plus with camera calibration
⚠️ Requires camera alignment and calibration procedure. Standard backup camera is integrated into AVN unit, not separate module. 2021+ has improved resolution.
Intelligent Power Distribution Module (IPDM)1.5 hr R&Rdealer / factory tool +0.8 hr▸ programming details
📍 Engine compartment, driver side fender, mounted to inner fender panel
🔧 CONSULT-III Plus with NTIS subscription
⚠️ Controls fuel pump, cooling fans, horn, and multiple power distribution functions. Also houses NATS immobilizer. VIN programming required.
📍 Engine compartment, driver side fender, integrated into Intelligent Power Distribution Module
🔧 CONSULT-III Plus with NTIS subscription
⚠️ Integrated with IPDM. All Intelligent Keys must be re-registered after replacement. Immobilizer pairing with ECM required. Some high-end aftermarket tools (Autel IM608 Pro) can program keys.
Intelligent Driver Alertness Control Module (I-DA)1.5 hr R&Rdealer / factory tool +0.5 hrSL and Platinum with Intelligent Driver Alertness (2021+)▸ programming details
📍 Behind instrument panel, integrated with BCM or cluster
🔧 CONSULT-III Plus
⚠️ Monitors driver attention and steering patterns. Software-based function integrated with other modules; rarely requires standalone replacement. Calibration via CONSULT-III Plus.
Radar Control Module (RADAR)1.5 hr R&Rdealer / factory tool +1.0 hrStandard on SV and above with Safety Shield 360 (ProPILOT Assist on SL/Platinum)▸ programming details
📍 Behind front bumper, center, behind lower grille
🔧 CONSULT-III Plus with radar alignment tool
⚠️ Forward collision warning and adaptive cruise control. Requires precise alignment with special target after replacement or front-end collision repair. 2021+ has enhanced radar range.
Telematics Control Unit (TCU)1.5 hr R&Rdealer / factory tool +0.8 hrStandard on SV and above with NissanConnect Services▸ programming details
📍 Behind instrument panel, passenger side, near glove box
🔧 CONSULT-III Plus with NTIS subscription and Nissan server activation
⚠️ Requires Nissan server activation and subscription pairing. Controls remote services, emergency call, stolen vehicle tracking. 2021+ has enhanced connectivity features.
Transfer Control Module (TCCM)1.5 hr R&Raftermarket tool +0.3 hrAWD models (standard on SL and Platinum; optional on S and SV)▸ programming details
📍 Under vehicle, mounted to transfer case assembly
🔧 CONSULT-III Plus or Autel
⚠️ Controls AWD engagement and torque distribution. Basic relearn procedure required after replacement. 2021+ has refined AWD logic.
📍 Behind instrument panel, center console area, near BCM
🔧 CONSULT-III Plus with NTIS subscription
⚠️ Manages CAN bus communication between networks. VIN programming required. 2021+ has enhanced security protocols but still not full SGW lockout like European brands.
Power Back Door Control Module (PBD)1.2 hr R&Raftermarket tool +0.3 hrSL and Platinum trims with power liftgate▸ programming details
📍 Rear liftgate, driver side, behind interior trim panel
🔧 CONSULT-III Plus or Autel
⚠️ Height memory and pinch protection calibration required after replacement. 2021+ Platinum adds hands-free kick sensor functionality.
📍 Engine compartment, driver side firewall, mounted on bulkhead above brake master cylinder
🔧 CONSULT-III Plus with NTIS subscription
⚠️ VIN programming and immobilizer pairing required. 2021+ models have enhanced security. Some aftermarket tools (Autel MaxiSys Ultra) can program with proper security credentials.
Automatic Air Conditioning Control Module (A/C)1.2 hr R&Rrelearn only +0.2 hr▸ programming details
📍 Behind center instrument panel, integrated into climate control head unit
🔧 Self-relearn procedure or CONSULT-III Plus
⚠️ Automatic climate control models. Self-calibration procedure available via button sequence. Manual climate control models use simple switch panel with no module.
Audio Visual Navigation Unit (AVN)1.0 hr R&Rrelearn only +0.3 hr▸ programming details
📍 Center instrument panel, integrated into touchscreen head unit
🔧 Self-initialization or CONSULT-III Plus
⚠️ 2021+ uses updated NissanConnect system with larger touchscreen (8-inch or 9-inch). Automatic CAN bus initialization on startup. Backup camera calibration may be needed.
Supplemental Restraint System Control Module (SRS)1.0 hr R&Rdealer / factory tool +0.5 hr▸ programming details
📍 Center console, beneath center stack, behind climate controls
🔧 CONSULT-III Plus with NTIS subscription
⚠️ Disconnect battery and wait 3 minutes before removal. VIN programming and crash data initialization required. Some aftermarket tools can clear codes but not program new modules.
Adaptive Front Lighting System Control Module (AFS)1.0 hr R&Raftermarket tool +0.3 hrSL and Platinum trims with LED headlights and adaptive lighting▸ programming details
📍 Behind front bumper, driver side, near headlight assembly
🔧 CONSULT-III Plus or Autel
⚠️ Controls headlight leveling and cornering function. Headlight aim calibration required after replacement. 2021+ Platinum has matrix LED headlights with expanded functionality.
⚠️ Odometer programming required to transfer mileage. VIN programming required. Federal law requires documentation of mileage transfer. 2021+ uses fully digital cluster on higher trims.
Sonar Control Module (SONAR)0.8 hr R&Raftermarket tool +0.2 hrStandard on SV and above with rear parking sensors; front sensors on SL/Platinum▸ programming details
📍 Behind rear bumper, center, above hitch area
🔧 CONSULT-III Plus or Autel
⚠️ Controls front and rear parking sensors. Sensor calibration typically automatic but can be manually triggered. 2021+ has expanded sensor coverage.
Driver Seat Control Module (DSCM)0.8 hr R&Rrelearn only +0.1 hrSL and Platinum with power driver seat and memory function▸ programming details
📍 Under driver seat, integrated into seat frame
🔧 Self-relearn via seat memory buttons
⚠️ Controls power seat adjustment and memory positions. Memory positions stored in module; relearn via seat memory buttons after replacement. 2021+ Platinum has heated/ventilated seats controlled by this module.
Power Window Master Switch (PWMS)0.5 hr R&Rrelearn only +0.1 hr▸ programming details
📍 Driver door, integrated into master window switch assembly
🔧 Manual auto-up/down initialization procedure
⚠️ Controls all four power windows. Auto-up/down relearn required via window switch procedure after replacement or battery disconnect.
Aftermarket tool coverage varies by software version and vehicle build — treat "aftermarket tool" rows as "usually possible" and verify against your tool maker's coverage list before promising a customer. Spot a wrong location or hour? Tell us — corrections ship fast here.
POWER TRAIN:AUTOMATIC TRANSMISSION:GEAR POSITION INDICATION (PRNDL) · 26V419000
2026-06-30
Nissan North America, Inc. (Nissan) is recalling certain 2026 Rogue vehicles. The instrument panel may not display the transmission gear selection indicator. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 102, "Transmission Shift Lever Sequence, Starter Interlock, and Transmission Braking Effect."
Consequence: A missing gear selection indicator may lead to unintended vehicle movement or a vehicle rollaway, increasing the risk of a crash.
Remedy: Dealers will inspect and replace the transmission control valve assembly as necessary, free of charge. Owner notification letters are expected to be mailed August 19, 2026. Owners may contact Nissan's customer service at 800-647-7261. Nissan's number for this recall is PD198. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on July 2, 2026.
TIRES:TEMPORARY/EMERGENCY SPARE TIRE · 25V912000
2025-12-23
Nissan North America, Inc. (Nissan) is recalling certain 2026 Rogue vehicles. The incorrect-size spare tire may have been installed, which does not match the tire size and inflation pressure information on the tire placard. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."
Consequence: Incorrect spare tire pressure information on the placard may lead to incorrect inflation of the spare tire, increasing the risk of a crash.
Remedy: Dealers will inspect and replace the spare tire assembly as necessary, free of charge. Owner notification letters were mailed February 25, 2026. Owners may contact Nissan's customer service at 800-647-7261. Nissan's number for this recall is PD180. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on January 6, 2026.
Wiper blades
Fourth generation (T33) continued - future model year estimate based on current generation
Size-standard part numbers — verify your connector type before buying. Rear blades are model-specific; check the package's vehicle list.
Fuel economy figures are EPA data via fueleconomy.gov (median across matching trims). Performance figures are compiled estimates for the 2026 Nissan Rogue 2.5L I4 and can vary by trim.
🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years and Jeff Moore · Master Lexus & Toyota Mechanic · 20+ years.