engine
Camshaft Position Sensor
for 1961-1966 Oldsmobile Dynamic 425 V8 · RWD
🔢What's included: time shown is for ONE component. V-type and DOHC engines carry this part per bank or per camshaft — a V8 may have two to four — and access often differs side to side (rear bank on transverse engines runs longer).
🔓 Step-by-step procedure: not written yet
For $3, we'll write the full Camshaft Position Sensor procedure for the 1961-1966 Oldsmobile Dynamic — steps, torque values, tips — and it becomes free for every owner on earth, forever, with your name on it. Usually live within the hour.
Original documentation, honestly labeled — and pages keep improving after you buy, as corrections and factory references land. How our data is made →
Labor Hours
1hr
Range: 0.8–1.2 hr
Data quality
Book-style estimate
Not yet expert-verified. Have the real number? Correct it below — takes 30 seconds.
At (your shop rate)
$150
Estimated labor cost. Parts not included. Rate saves to this browser and the quote builder.
Other labor times on this vehicle
Camshaft Position Sensor on similar vehicles
1961-1966 Oldsmobile Dynamic 394 cu in (6.5L) Skyrocket V8, 2-bbl, 250 hp (regular fuel)
1 hr
1958-1960 Oldsmobile Dynamic 371 cu in (6.1L) Rocket V8, 2-bbl, 265 hp
1 hr
1967 Oldsmobile Delmont 330 V8
1 hr
1967 Oldsmobile Delmont 425 V8
1 hr
1970 Oldsmobile Rallye 350 5.7L V8
1 hr
1975-1980 Oldsmobile 442 5.0L V8
1 hr