Free API
5.7L V84WDgasHEMI
Founding sponsor spot is openYour name on every procedure for this vehicle, permanently.Sponsor — $99 →
P0912high severityPowertrain

Gate Select Position Circuit Low

on 2005 Ram 1500 5.7L V8 · 4WD

What this code means

The gate select position circuit voltage is reading lower than normal. This usually points to a short to ground or sensor failure in the shift-by-wire system.

Symptoms

  • No or erratic shifting
  • Transmission fault light
  • Limp mode

Common causes

  • Short to ground in wiring
  • Faulty gate select position sensor
  • Corroded connector pins
  • Failed transmission control module

Diagnostic steps

  1. Retrieve and record trouble codes
  2. Check gate select sensor signal wire for short to ground
  3. Backprobe sensor voltage at connector
  4. Replace sensor if out of spec

Other Powertrain codes on this vehicle

🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years. Spot an error? Use the Help link above — a human reads every report.
Stuck on this repair? Take it to The Diag Desk — ask a master tech about this exact car → real human answer within 24h, never AI
⚠ STILL BEHIND THE PAYWALL
The 2005 Ram 1500 repair data is incomplete because no one has sponsored it yet. For $99, we generate the full step-by-step procedures, then fact-check them with a second AI pass and your expert review. Your name on every procedure, permanently.
The same data would cost $169/mo from Mitchell1 or $30/year from ALLDATAdiy — and you'd be renting access, not freeing it. Sponsor once, free forever.
Sponsor the Ram 1500 — $99 →
Building an app?
Free API access to all this data — 10 requests/day, no card required.
Get an API key →
Run a shop?
Manage repairs, estimates, and customers with ShopBase — $249/mo, all features included.
Try ShopBase →