P0825moderate severityPowertrain
Gear Lever Push-Pull Switch (Shift Anticipate)
on 2014 Ram 2500 6.7L I6 Cummins Diesel · 4WD
What this code means
A fault has been detected in the gear lever push-pull switch circuit used to anticipate driver shift intent. This can affect shift timing and gear selection response.
Symptoms
- Delayed or missed shifts
- Transmission warning light on
- Shift anticipation not working
Common causes
- Faulty push-pull switch
- Damaged wiring or connector
- Poor ground or open circuit
- Faulty transmission control module
Diagnostic steps
- Read stored codes and freeze frame data
- Test push-pull switch operation with scan tool
- Inspect switch wiring and connectors
- Replace switch or repair circuit as needed
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0005
Fuel Shutoff Valve A Control Circuit/Open
P0006
Fuel Shutoff Valve A Control Circuit Low
P0007
Fuel Shutoff Valve A Control Circuit High
P0008
Engine Position System Performance - Bank 1
P0009
Engine Position System Performance - Bank 2
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1