P1092moderate severityPowertrain
Tumble Generator Valve 2 LH Stuck Open
on 2010 Subaru Outback 3.6L H6 · AWD
What this code means
The PCM has detected that the Tumble Generator Valve 2 on the left-hand cylinder bank is stuck in the open position. This is the left bank counterpart of P1090.
Symptoms
- Check Engine Light
- Reduced low-load efficiency
- Slightly rough idle
- Higher emissions at idle
Common causes
- Carbon buildup on LH TGV
- Failed LH TGV actuator
- Broken linkage on LH side
- LH TGV shaft binding
- LH actuator wiring fault
Diagnostic steps
- Command TGV 2 closed and monitor position
- Inspect LH TGV valve for carbon
- Test LH TGV actuator motor
- Check LH linkage condition
- Test actuator circuit
Repair notes
Clean carbon from the LH TGV; replace the actuator if the motor has failed.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1