P3003moderate severityPowertrain
Turbo/Supercharger Boost Pressure Sensor Circuit Intermittent
on 2010 Subaru Outback 3.6L H6 · AWD
What this code means
The boost pressure sensor signal is intermittent, causing erratic boost control. The PCM detects signal dropouts or sudden voltage changes.
Symptoms
- Check Engine Light intermittent
- Fluctuating boost gauge
- Inconsistent power delivery
- Occasional limp mode
- Surging under load
Common causes
- Loose boost pressure sensor connector
- Damaged sensor wiring
- Faulty boost pressure sensor
- Vibration-related intermittent contact
- Corroded sensor pins
Diagnostic steps
- Monitor boost pressure PID for signal dropouts
- Wiggle test on sensor connector while monitoring data
- Inspect sensor connector pins for corrosion
- Check wiring harness routing near heat sources
- Swap sensor with known good unit if available
Repair notes
Replace boost pressure sensor or repair intermittent wiring connection.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1