P1097moderate severityPowertrain
Tumble Generator Valve Circuit 2 Over Current
on 2015 Subaru Outback 2.5L H4 · AWD
What this code means
The PCM has detected an overcurrent condition in the Tumble Generator Valve 2 actuator circuit on the left-hand bank. The LH actuator is drawing excessive current.
Symptoms
- Check Engine Light
- TGV 2 erratic operation
- Possible fuse or PCM driver protection activation
Common causes
- LH TGV actuator internally shorted
- Wiring short in LH circuit
- Mechanical binding of LH TGV
- Water damage to actuator
- Connector fault
Diagnostic steps
- Test TGV 2 actuator resistance
- Inspect LH wiring for shorts
- Check LH TGV for mechanical binding
- Look for moisture intrusion
- Isolate circuit and retest
Repair notes
Replace the LH TGV actuator if internally shorted; repair wiring and free any mechanical binding.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0010
Intake Camshaft Position Actuator Circuit/Open Bank 1
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1