C1336moderate severityChassis
Zero Point Calibration of Deceleration Sensor Undone
on 2000 Toyota 4Runner 2.7L I4 · 4WD
What this code means
The deceleration sensor has not had its zero point calibrated after service. No direct OBD P-code equivalent exists.
Symptoms
- ABS warning light on
- VSC/TRC light on
- Stability control inactive
Common causes
- Calibration not performed after repair
- Battery or ECU replaced
- Sensor recently installed
- Faulty skid control ECU
Diagnostic steps
- Confirm sensor is mounted properly
- Perform zero point calibration with scan tool
- Verify vehicle level during calibration
- Clear codes and road test
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Chassis codes on this vehicle
C0021
LF Wheel Speed Sensor Range/Performance
C0022
RF Wheel Speed Sensor Range/Performance
C0023
LR Wheel Speed Sensor Range/Performance
C0024
RR Wheel Speed Sensor Range/Performance
C0025
LF Wheel Speed Sensor Circuit Intermittent
C0026
RF Wheel Speed Sensor Circuit Intermittent
C0027
LR Wheel Speed Sensor Circuit Intermittent
C0028
RR Wheel Speed Sensor Circuit Intermittent
C0035
Left Front Wheel Speed Sensor Circuit
C0036
Left Front Wheel Speed Signal Erratic