Side Mirror Assembly

This procedure covers the removal and replacement of the side mirror assembly on a 2018-2024 Toyota Camry with the 2.5L I4 engine, including electrical connector disconnection and trim panel removal.

Warnings

Tools required

Parts

• Side mirror assembly (left or right) × 1 — Use OEM specification
• Door trim panel clips (if broken) × 1 — Use OEM specification

Preparation

1. Park vehicle on level surface and engage parking brake
2. Turn ignition to OFF position and remove key
3. Open the driver or passenger door (whichever side mirror is being replaced)
4. Roll down the window slightly for easier access if needed

Procedure

1. 1

   Remove door trim panel speaker cover
   Using a trim removal tool, carefully pry off the triangular speaker cover at the front upper corner of the door panel where it meets the mirror. Start at the rear edge and work forward. This cover snaps into place with clips. Set aside in a safe location.
2. 2

   Disconnect mirror electrical connector
   Locate the electrical connector behind the speaker cover area. Press the locking tab and pull the connector straight out to disconnect it from the mirror assembly. If equipped with multiple connectors (for power folding, heating, or blind spot monitoring), disconnect all connectors. Note the routing of the wiring harness for reassembly.
3. 3

   Remove mirror mounting bolts
   Using a 10mm socket and ratchet, remove the three bolts securing the mirror assembly to the door frame. These bolts are accessed through the opening where the speaker cover was removed. Support the mirror from the outside with your other hand to prevent it from falling once the bolts are removed.
4. 4

   Remove mirror assembly from door
   With all three mounting bolts removed, carefully pull the mirror assembly away from the door. Guide the wiring harness through the door opening to completely separate the mirror from the vehicle. Be careful not to scratch the door paint during removal.
5. 5

   Install new mirror assembly
   Feed the wiring harness of the new mirror through the door opening from outside to inside. Align the mirror base with the three mounting holes on the door frame. Hold the mirror in position from the outside while preparing to install the bolts.
6. 6

   Install and torque mirror mounting bolts
   Thread in all three mounting bolts by hand first to ensure proper alignment. Once all bolts are started, use a torque wrench to tighten each bolt in a cross pattern to ensure even pressure. Torque all three bolts to specification.
   Torque spec

   Module Mounting Bolts8 Nm (6 lb-ft)
7. 7

   Reconnect electrical connector(s)
   Connect the electrical connector(s) to the mirror assembly, ensuring each connector clicks firmly into place. Verify the locking tab engages properly. Route the wiring harness as noted during disassembly to avoid pinching.
8. 8

   Reinstall speaker cover trim panel
   Align the triangular speaker cover with the door panel and mirror area. Ensure all clips are properly positioned, then press firmly around the perimeter until all clips snap into place. Verify the cover sits flush with the surrounding trim.

Reassembly

1. Ensure all electrical connectors are fully seated and locked
2. Verify the speaker cover trim panel is flush and all clips are engaged
3. Check that no wiring is pinched or visible between panels

Verification

• Turn the ignition to ON (engine off) and verify mirror power adjustment works in all directions
• If equipped, test the mirror heating function and turn signal indicator
• If equipped with power folding, test the fold and unfold operation
• Visually inspect the mirror to ensure it is securely mounted with no movement or vibration
• Check that all trim panels are properly seated and aligned with no gaps

Related trouble codes on this vehicle

Codes that commonly send this job to the bay — tap one for symptoms, causes, and diagnostic steps.

Chasing one of these codes and not sure which part is guilty? Ask a master mechanic about YOUR car →

More procedures for this vehicle