P0793moderate severityPowertrain
Intermediate Shaft Speed Sensor Circuit No Signal
on 1998 Toyota Tacoma 2.7L I4 · RWD
What this code means
No signal is being received from the intermediate shaft speed sensor. The transmission cannot properly determine shaft speed.
Symptoms
- No or delayed shifting
- Transmission stuck in limp mode
- Warning light illuminated
Common causes
- Failed intermediate shaft speed sensor
- Open circuit in sensor wiring
- Corroded or disconnected connector
- Faulty transmission control module
Diagnostic steps
- Scan for no-signal fault confirmation
- Check connector for power and ground
- Test wiring continuity to TCM
- Replace sensor if signal absent
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Budget handheld~$40
ANCEL AD410 →
No-phone-needed handheld — reads, clears, live data, freeze frame.
✓ ANCEL official store
Serious DIY~$100
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
SHOP FAVORITEShop-grade tablet~$300
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
✓ Autel official store
Pro diagnostics$1,500+
Autel MaxiSys MS906 Pro →
Full-system pro platform — topology mapping, ECU coding, the works.
✓ Autel official store
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0004
Fuel Volume Regulator Control Circuit High
P0005
Fuel Shutoff Valve A Control Circuit/Open
P0005
Fuel Shutoff Valve A Control Circuit/Open