P0010moderate severityPowertrain
Intake Camshaft Position Actuator Circuit/Open Bank 1
on 2008 Volkswagen Gol 1.0L I4 Flex · FWD
What this code means
The PCM detected a malfunction in the intake camshaft position actuator circuit for Bank 1. The VVT solenoid controls oil flow to the camshaft phaser.
Symptoms
- Check Engine Light
- Rough idle
- Reduced power
- Engine rattle on startup
Common causes
- Faulty VVT solenoid
- Low oil level or dirty oil
- Wiring issue
- Camshaft phaser failure
Diagnostic steps
- Check engine oil level and condition
- Test VVT solenoid resistance
- Inspect wiring to solenoid
- Command solenoid on/off with scan tool
- Check oil pressure
Repair notes
Replace VVT solenoid or repair wiring. Ensure oil is clean and at proper level.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
00532
Supply Voltage B+ Signal too Low
16394
Camshaft/Crankshaft Position Correlation Bank 1
16395
Camshaft Position Actuator Circuit/Open Bank 1
16486
Mass or Volume Air Flow Circuit Low Input
16487
Mass or Volume Air Flow Circuit High Input
16500
Engine Coolant Temperature Circuit Malfunction
16501
Engine Coolant Temperature Circuit Low Input
16502
Engine Coolant Temperature Circuit High Input
16514
O2 Sensor Circuit Bank 1 Sensor 1
16515
O2 Sensor Circuit Low Voltage Bank 1 Sensor 1