P0010moderate severityPowertrain
Intake Camshaft Position Actuator Circuit/Open Bank 1
on 2009 Volvo S60 2.4L I5 · AWD
What this code means
The PCM detected a malfunction in the intake camshaft position actuator circuit for Bank 1. The VVT solenoid controls oil flow to the camshaft phaser.
Symptoms
- Check Engine Light
- Rough idle
- Reduced power
- Engine rattle on startup
Common causes
- Faulty VVT solenoid
- Low oil level or dirty oil
- Wiring issue
- Camshaft phaser failure
Diagnostic steps
- Check engine oil level and condition
- Test VVT solenoid resistance
- Inspect wiring to solenoid
- Command solenoid on/off with scan tool
- Check oil pressure
Repair notes
Replace VVT solenoid or repair wiring. Ensure oil is clean and at proper level.
🔌 Don't have a code reader?
Any of these will read and clear this code — pick by how deep you want to go.
Bluetooth code reader (~$25)
Veepeak OBDCheck BLE →
Pairs with your phone — reads and clears codes, live data.
Serious DIY (~$100)
BlueDriver Pro →
Enhanced codes (ABS, airbag, TPMS) plus repair reports.
Shop-grade tablet (~$300+)
Autel MaxiCOM MK808S →
Bidirectional tests, service resets, all systems.
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Other Powertrain codes on this vehicle
P0001
Fuel Volume Regulator Control Circuit/Open
P0002
Fuel Volume Regulator Control Circuit Range/Performance
P0003
Fuel Volume Regulator Control Circuit Low
P0004
Fuel Volume Regulator Control Circuit High
P0011
Intake Camshaft Position Timing Over-Advanced Bank 1
P0012
Intake Camshaft Position Timing Over-Retarded Bank 1
P0013
Exhaust Camshaft Position Actuator Circuit/Open Bank 1
P0014
Exhaust Camshaft Position Timing Over-Advanced Bank 1
P0015
Exhaust Camshaft Position Timing Over-Retarded Bank 1
P0016
Crankshaft Position/Camshaft Position Correlation Bank 1 Sensor A