The 2021 Chevrolet Tracker MX (rebadged Chinese-market crossover) uses small-displacement turbo three-cylinders that experience premature wear under stress. Transmission mounts fail early, and the 1.2L especially shows lifter/timing-chain issues before 100k miles.
Collapsed Lifters and Timing Chain Stretch (1.2L Turbo)
Common · high severity
Typical onset: 60,000-90,000 mi
Symptoms: Cold-start rattle for 2-5 seconds that worsens over time, Check engine light with variable valve timing codes (P0011, P0014), Loss of power, rough idle, potential engine damage if ignored
Fix: Replace timing chain, guides, tensioner, and all lifters. Often involves cylinder head removal to verify cam lobe wear. 12-16 labor hours at indie shop rates.
Estimated cost: $2,800-4,200
Premature Transmission Mount Failure
Common · medium severity
Typical onset: 35,000-70,000 mi
Symptoms: Clunking or banging on acceleration/deceleration, Excessive vibration at idle in Drive, Visible sagging or torn rubber on driver-side mount
Fix: Replace driver-side transmission mount (cheaply made OEM part). 1.5-2 hours labor. Upgraded aftermarket mounts hold up better.
Estimated cost: $250-450
Cylinder Head Warping (1.0L and 1.2L)
Occasional · high severity
Typical onset: 70,000-110,000 mi
Symptoms: Coolant loss without visible leaks, White smoke from exhaust on cold starts, Overheating episodes, bubbling in coolant reservoir, Misfires on one or more cylinders
Fix: Cylinder head removal, pressure test, resurface or replace. Often combines with timing chain/lifter job. 10-14 hours labor depending on extent of damage.
Estimated cost: $2,200-3,800
Transmission Oil Cooler Line Leaks
Occasional · medium severity
Typical onset: 50,000-85,000 mi
Symptoms: Transmission fluid spots under vehicle (red or brown), Burning smell after highway driving, Transmission running hotter than normal (if equipped with temp gauge)
Fix: Replace cooler lines and reseal cooler connections. Sometimes the cooler itself fails. 2-3 hours labor plus fluid flush.
Estimated cost: $400-750
Harmonic Balancer Separation
Occasional · high severity
Typical onset: 80,000-120,000 mi
Symptoms: Loud squealing or grinding from front of engine, Serpentine belt throwing off repeatedly, Visible wobble on crankshaft pulley at idle, Check engine light with crankshaft position sensor codes
Fix: Replace harmonic balancer and serpentine belt. Inspect for crank snout damage. 2-3 hours labor. Critical repair—can destroy timing components if balancer fully separates.
Symptoms: Hesitation or stumble under hard acceleration, Difficulty starting when fuel tank is below 1/4, Loss of power on highway grades
Fix: Replace in-line fuel filter (sometimes integral with fuel pump module). 1-2 hours labor depending on access. More frequent in regions with poor fuel infrastructure.
Estimated cost: $180-400
Owner tips
Use top-tier fuel and change oil every 5,000 miles maximum with 0W-20 or 5W-30 full synthetic—these tiny turbos are brutal on oil
Inspect transmission mount at every oil change after 30k miles; replacing it early avoids driveline stress
Watch coolant level religiously—head gasket/warping issues can escalate fast on these aluminum heads
Budget $3,000-5,000 for major engine work between 60k-100k miles if buying used—timing chain and lifter jobs are nearly inevitable on the 1.2L
Buy only if under warranty or priced $3k below market to cover inevitable engine work; the 1.0L is slightly more reliable than the 1.2L, but both platforms are high-maintenance for a modern crossover.
AI-assisted summary drawn from NHTSA recall data, our labor-times database, and platform knowledge. Not a substitute for a pre-purchase inspection on a specific vehicle.
Fitment notes: Compact battery for small displacement turbocharged engine
As an Amazon Associate, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Every control module on the 2020-2026 Chevrolet Tracker MX — where it lives, replacement time, and what it takes to program a replacement. Modules marked dealer / factory tool won't work after a part swap alone — budget for programming.
📍 Front grille area, behind front bumper cover, center mounted
🔧 GM SPS2 via MDI2
⚠️ Radar aiming and calibration required; static or dynamic calibration procedure; alignment critical
Body Control Module (BCM)1.5 hr R&Rsecurity gateway +1.0 hr▸ programming details
📍 Behind instrument panel, left side of steering column, above fuse block
🔧 GM SPS2 / Techline Connect
⚠️ Controls lighting, door locks, wipers, horn, power windows; VIN and vehicle configuration programming required; aftermarket tools often fail on BCM replacement
📍 Center console, beneath floor shifter trim, mounted to transmission tunnel
🔧 GM SPS2 / Techline Connect
⚠️ Battery disconnect and 2-minute wait mandatory before removal; VIN and crash data programming required; never reuse after deployment
Headlamp Control Module (HCM)0.8 hr R&Raftermarket tool +0.3 hrwith automatic headlamps or LED/HID▸ programming details
📍 Behind front bumper, driver side headlamp assembly
🔧 GM SPS2 or Autel
⚠️ Configuration for DRL and automatic headlamp operation; basic function without coding on some variants
Remote Control Door Lock Receiver / Theft Deterrent Module (RCDLR)0.7 hr R&Rdealer / factory tool +0.4 hr▸ programming details
📍 Behind instrument panel, center console area, near BCM
🔧 GM SPS2 / Techline Connect
⚠️ Key fob programming and immobilizer relearn required; all keys must be reprogrammed after replacement
Fuel Pump Control Module (FPCM)0.6 hr R&Rrelearn only +0.2 hr▸ programming details
📍 Under vehicle, forward of fuel tank, mounted to frame rail driver side
🔧 Scan tool auto-relearn
⚠️ Self-learns after key cycles; no formal programming typically required
Rear Vision Camera Module (RVCM)0.5 hr R&Rno coding▸ programming details
📍 Integrated with rear liftgate handle assembly, center of liftgate
⚠️ Plug-and-play replacement; no programming required; camera calibration lines displayed by ICM
Tire Pressure Monitor Control Module (TPMS)relearn only +0.2 hr▸ programming details
📍 Integrated within BCM; no separate physical module
🔧 TPMS relearn tool or scan tool
⚠️ Sensor ID relearn required after tire rotation or sensor replacement; BCM handles TPMS processing
Aftermarket tool coverage varies by software version and vehicle build — treat "aftermarket tool" rows as "usually possible" and verify against your tool maker's coverage list before promising a customer. Spot a wrong location or hour? Tell us — corrections ship fast here.
📝 Chevrolet Tracker MX (Mexican market crossover, based on global platform). Standard hook-type attachment for front wipers, rear wiper typically hook or specific clip style
Chevrolet Tracker MX (Mexican market crossover, based on global platform). Standard hook-type attachment for front wipers, rear wiper typically hook or specific clip style
Size-standard part numbers — verify your connector type before buying. Rear blades are model-specific; check the package's vehicle list.
Fuel economy figures are EPA data via fueleconomy.gov (median across matching trims). Performance figures are compiled estimates for the 2021 Chevrolet Tracker MX 1.2L I3 Turbo Ecotec and can vary by trim.
🔧 Database maintained under the daily editorial review of Chris Hackleman · Master Technician · 20+ years and Jeff Moore · Master Lexus & Toyota Mechanic · 20+ years.