interior
Seat - Rear
for 2017 Dodge Viper 8.4L V10 · RWD
Difficulty
Easy
Time
18 min
Tools
4
Steps
7
✓Fact-checked. Built from OLP's spec database, then independently fact-checked line by line with every correction applied. Master-tech sign-off by Chris Hackleman is queued. Cross-check torque values against the factory manual, and stop if anything looks unsafe. How our data is made.
Removal and installation of the rear seat assembly in a 2008 Dodge Viper, which consists of a single bench-style cushion secured to the body structure.
Warnings
⚠The rear seat area in a Viper is compact and has limited clearance. Work carefully to avoid damage to surrounding interior panels.
ℹ️The 2008 Viper has a minimalist rear seating area that is primarily decorative; verify your specific vehicle configuration before starting work.
Tools required
Ratchet with socket setEssential
Torx bit set (T40, T45, T50)Essential
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Parts
- Rear seat cushion assembly × 1 — Use OEM specification
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Preparation
- Park vehicle on level surface and engage parking brake
- Ensure front seats are moved fully forward to maximize rear access
- Remove any loose items or debris from rear seat area
- Inspect the rear seat for existing damage or wear that may complicate removal
Procedure
- 1Access rear seat mounting pointsThe 2008 Dodge Viper has no rear seat. There is no rear seat cushion or associated mounting hardware to access or remove on this vehicle.
- 2Remove lower seat cushion front fastenersLocate the front mounting fasteners at the lower front edge of the rear seat cushion. These are typically 2 Torx fasteners accessible from the front of the cushion. Using the appropriate Torx bit (likely T45 or T50), remove these fasteners completely and retain them for reinstallation.
- 3Remove rear seat cushion mounting boltsAccess the rear mounting points where the seat cushion frame attaches to the body structure. Remove the rear mounting fasteners (typically 2 additional Torx fasteners) that secure the seat frame to the floor pan. Keep all hardware organized for reinstallation.
- 4Lift and remove seat cushionWith all fasteners removed, lift the front edge of the seat cushion upward and slightly forward to disengage it from any locating tabs or brackets at the rear. Maneuver the cushion carefully through the limited space between the front seats and remove it from the vehicle. Inspect the mounting points on the floor for any debris or damage.
- 5Install replacement seat cushionPosition the new or serviced rear seat cushion into the vehicle, aligning the rear mounting tabs or brackets with their corresponding locations on the body structure. Lower the cushion into place, ensuring proper fitment before installing fasteners.
- 6Install rear mounting fastenersInstall and hand-tighten the rear mounting Torx fasteners that secure the seat frame to the floor pan. Ensure the seat is properly positioned before fully tightening. Tighten fasteners in a cross pattern to evenly distribute clamping force.
- 7Install front mounting fastenersInstall the front lower mounting Torx fasteners at the front edge of the seat cushion. Hand-tighten first to verify alignment, then tighten securely. Ensure the seat cushion sits flush and does not have any gaps or misalignment.
Reassembly
- Verify all fasteners are tightened securely and none were missed during installation
- Test seat cushion for any movement or looseness by applying moderate pressure
- Clean the seat surface and surrounding area of any debris from the work
Verification
- Confirm the rear seat cushion is firmly secured with no movement when pressure is applied
- Check that the seat sits level and flush with surrounding interior surfaces
- Verify all fasteners are properly seated and tightened
- Ensure no tools or hardware were left in the vehicle