steering
Power Steering Hose - High Pressure
for 2017 Ford F-150 3.5L V6 EcoBoost · RWD
Editorial review:Chris Hackleman — Master Technician · 20+ years · Jeff Moore — Master Mechanic · 20+ years
Difficulty
Easy
Time
1.2 h
Tools
3
Steps
3
✓Expert-verified. Personally reviewed and approved by OLP's master technicians (Chris Hackleman & Jeff Moore — 20+ years each). Always follow the vehicle's factory service information and torque specs.
This procedure replaces the high-pressure power steering hose on a 2015-2020 Ford F-150 with the 3.5L EcoBoost engine. Note that these vehicles use Electric Power Assisted Steering (EPAS) and do not have a traditional hydraulic power steering system with a high-pressure hose.
Warnings
⚠The 2015-2020 Ford F-150 with 3.5L EcoBoost uses Electric Power Assisted Steering (EPAS), which has no hydraulic pump, fluid reservoir, or high-pressure hoses. There is no high-pressure power steering hose to replace on this vehicle.
ℹ️If you are experiencing power steering issues, diagnose the electric power steering motor, steering column components, or electronic control systems instead.
ℹ️This procedure cannot be performed as specified because the required component does not exist on this vehicle configuration.
Tools required
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Preparation
- Verify that your vehicle actually has a hydraulic power steering system before proceeding
- Consult your vehicle's owner manual or check under the hood for a power steering fluid reservoir - EPAS-equipped vehicles will not have one
- If you have confirmed your vehicle has hydraulic power steering (non-standard configuration), obtain the correct replacement hose before beginning work
Procedure
- 1Verify steering system typeOpen the hood and look for a power steering fluid reservoir on the passenger side of the engine bay. The 3.5L EcoBoost F-150 uses Electric Power Assisted Steering (EPAS) and will not have a reservoir, pump, or hydraulic hoses. If no reservoir is present, this repair does not apply to your vehicle.
- 2Identify actual steering concernIf experiencing steering issues on an EPAS-equipped vehicle, the problem is likely related to the electric steering motor (located on the steering column), wiring harness connections, steering angle sensor, or the power steering control module. Use a diagnostic scan tool to check for power steering fault codes.
- 3Consult alternative repair proceduresFor EPAS-equipped vehicles, refer to electric power steering motor replacement, steering column service, or electronic diagnostic procedures instead of hydraulic hose replacement. The electric motor is mounted on the steering column inside the vehicle.
Reassembly
- This procedure does not apply to the specified vehicle configuration
- No reassembly steps are required as no disassembly should have occurred
Verification
- Confirm your vehicle's steering system type by checking the owner's manual or looking for the absence of a power steering fluid reservoir
- If you have steering concerns, verify proper operation of the electric power steering system using a diagnostic scan tool
- Ensure no fault codes are present in the power steering control module
Related trouble codes on this vehicle
Codes that commonly send this job to the bay — tap one for symptoms, causes, and diagnostic steps.
P0087Fuel Rail/System Pressure - Too LowP0088Fuel Rail/System Pressure - Too HighP0090Fuel Pressure Regulator 1 Control CircuitP0091Fuel Pressure Regulator 1 Control Circuit LowP0105Manifold Absolute Pressure/BARO CircuitP0106MAP/BARO Pressure Circuit Range/PerformanceP0190Fuel Rail Pressure Sensor CircuitP0191Fuel Rail Pressure Sensor Circuit Range/PerformanceP0452EVAP Pressure Sensor/Switch Low InputP0453EVAP Pressure Sensor/Switch High InputP0520Engine Oil Pressure Sensor/Switch CircuitP0521Engine Oil Pressure Sensor/Switch Range/Performance
Chasing one of these codes and not sure which part is guilty? Ask a master mechanic about YOUR car →