interior
Floor Mat Hooks
for 2007 Ram 3500 5.9L I6 Cummins · 4WD
Difficulty
Easy
Time
6 min
Tools
3
Steps
5
✓Fact-checked. Built from OLP's spec database, then independently fact-checked line by line with every correction applied. Master-tech sign-off by Chris Hackleman is queued. Cross-check torque values against the factory manual, and stop if anything looks unsafe. How our data is made.
Install or replace floor mat retention hooks in the driver and passenger side footwells to secure factory or aftermarket floor mats.
Warnings
ℹ️Ensure vehicle is parked on level ground and ignition is off before working inside the cabin.
⚠If replacing damaged hooks, inspect carpet backing for tears or damage that may prevent secure installation.
Tools required
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Parts
- Floor mat hook retention clip × 2 — Mopar OEM or aftermarket equivalent
As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.
Preparation
- Remove all floor mats from driver and passenger side footwells
- Vacuum or clean carpet surface where hooks will be installed to remove dirt and debris
- Identify hook mounting location on carpet - typically center front of driver footwell near transmission tunnel and passenger footwell in similar location
Procedure
- 1Remove old floor mat hook (if replacing)If replacing an existing hook, inspect how the factory anchor is retained. On this vehicle the floor mat anchor is typically a molded plastic twist-lock or push-in retainer seated in the carpet rather than a metal screw threaded into the floor pan. Release the existing anchor per its retention style (twist to unlock or gently pry the base) and inspect the mounting area for damage.
- 2Locate mounting pointIdentify the factory floor mat anchor location, which is a fixed molded point in the carpet near the center-front of each footwell (not a measured position). Passenger side is in a similar relative position. If installing new anchors where none existed, verify placement will not interfere with floor mat edges or pedal operation on driver side.
- 3Install floor mat hookInstall the new floor mat anchor per its retention style. For a twist-lock anchor, align and rotate to lock; for a push-in retainer, press firmly until it seats. The base should sit flush against the carpet without excessive compression. If resistance is met, do not force - verify alignment.
- 4Tighten hook securelyConfirm the anchor is fully seated and locked by hand. No power tool is required for a twist-lock or push-in anchor. Do not overtighten or force a twist-lock anchor as this can damage the retainer or carpet backing. The anchor should be secure with minimal movement when tested by hand.
- 5Repeat for passenger sidePerform the same installation procedure for the passenger side floor mat hook. Ensure both hooks are installed at similar depths and sit flush with carpet surface.
Reassembly
- Reinstall floor mats, ensuring the grommet holes align properly with the installed hooks
- Verify mats are fully seated and hooks engage grommets securely
- Test mat retention by pulling upward on mat corner - it should remain anchored to hook without releasing
Verification
- Confirm both floor mat hooks are securely fastened and do not rotate freely when twisted by hand
- Verify floor mats are properly anchored and do not slide forward or interfere with pedal operation on driver side
- Check that hook heads protrude adequately through mat grommets to prevent accidental release during normal use