interior

Steering Wheel Cover

for 2007 Ram 3500 5.9L I6 Cummins · 4WD

Difficulty

Easy

Time

6 min

Tools

Steps

✓Fact-checked. Built from OLP's spec database, then independently fact-checked line by line with every correction applied. Master-tech sign-off by Chris Hackleman is queued. Cross-check torque values against the factory manual, and stop if anything looks unsafe. How our data is made.

This procedure covers the removal and installation of a steering wheel cover on a 2007 Ram 3500 with 5.9L Cummins diesel engine.

Warnings

⚠Ensure the vehicle is in Park (automatic) or in gear (manual) with the parking brake engaged before working inside the cabin

ℹ️Some aftermarket steering wheel covers may not fit properly due to variations in steering wheel diameter and design

Tools required

Flat-blade screwdriver or trim removal toolEssential

Clean cloth or microfiber towel

As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.

Parts

Steering wheel cover × 1 — Use OEM specification or aftermarket equivalent

As an Amazon Associate and Autel/ANCEL partner, OLP earns from qualifying purchases — how we link. This never changes the specs we publish.

Preparation

Park vehicle on level surface and engage parking brake
Turn ignition off and remove key
Allow steering wheel to cool if vehicle was recently operated in hot weather
Clean steering wheel surface with appropriate cleaner to ensure proper adhesion if using a slip-on style cover

Procedure

1
Remove old steering wheel cover (if applicable)
If replacing an existing cover, carefully pry off the old cover starting at the seam. For sewn-on covers, cut stitching with scissors or utility knife. For slip-on covers, work the cover off the wheel by pulling from one section and working around the circumference. Clean any adhesive residue from the steering wheel surface with appropriate cleaner.
2
Inspect steering wheel condition
Examine the underlying steering wheel for cracks, damage, or excessive wear. Check that the horn button is functioning properly and that no airbag warning lights are illuminated on the instrument cluster. WARNING: This steering wheel contains a driver airbag module in the center hub — do not install any cover that overlaps, covers, or restricts the airbag deployment area. Address any underlying issues before installing the new cover.
3
Position new steering wheel cover
Align the new cover with the top-center position of the steering wheel (12 o'clock position). For covers with logos or design elements, ensure they are properly oriented. Stretch the cover over the top section of the wheel, ensuring equal material on both sides.
4
Install steering wheel cover
For slip-on covers: Work the cover onto the wheel by pulling and stretching the material around the circumference. Use firm, even pressure to seat the cover completely. For lace-on covers: Thread the lacing cord through the provided holes starting at the bottom of the wheel and work your way around, maintaining even tension. For heat-shrink covers: Use a heat gun on low setting to shrink the material evenly around the wheel, working in sections.
5
Secure and finish cover installation
Ensure the cover is seated evenly around the entire steering wheel with no loose sections or bunching. For lace-on covers, tie off the lacing cord securely and trim excess. Verify the cover does not interfere with steering wheel controls, turn signal stalk, or any other dashboard components. Check that the horn is still accessible and functional.

Reassembly

No reassembly required for this procedure

Verification

Turn steering wheel full lock left and right to ensure cover does not slip or bunch
Test horn functionality by pressing the center of the steering wheel
Verify all steering wheel-mounted controls (if equipped) are accessible and functional
Check that the cover is seated evenly with no gaps or loose sections
Confirm the cover does not obstruct view of instrument cluster or interfere with turn signal operation