This procedure tests the charging system to verify the alternator is producing proper voltage and current, and that the battery is accepting charge correctly.

Warnings

Tools required

Preparation

1. Ensure vehicle has been driven for at least 10 minutes or battery is fully charged before testing
2. Turn off all electrical accessories (lights, HVAC, radio, etc.)
3. Allow engine to reach normal operating temperature
4. Park vehicle on level surface and apply parking brake

Procedure

1. 1

   Perform initial battery voltage test
   With engine off and all accessories off, set multimeter to DC volts. Connect red lead to positive battery terminal and black lead to negative terminal. Record voltage. A healthy battery should read 12.4-12.7V when fully charged. Below 12.4V indicates battery may need charging before proceeding with alternator test.
2. 2

   Start engine and verify idle charging voltage
   Start the engine and let it idle. With multimeter still connected to battery terminals, check voltage. Normal charging voltage should be 13.8-14.7V at idle. If voltage is below 13.5V or above 15.0V, the charging system has a fault.
3. 3

   Test charging voltage at 2000 RPM no load
   Increase engine speed to approximately 2000 RPM with all accessories off. Voltage should remain stable between 13.8-14.7V. Record the voltage reading. Voltage should not fluctuate more than 0.5V during this test.
4. 4

   Perform loaded charging system test
   With engine at 2000 RPM, turn on maximum electrical load: headlights on high beam, HVAC blower on high, rear defrost, and heated seats if equipped. Voltage should drop slightly but remain above 13.5V. If voltage drops below 13.0V, alternator output is insufficient and alternator should be tested further or replaced.
5. 5

   Check for voltage drop in charging circuit
   With engine running at idle and moderate electrical load applied, measure voltage directly at alternator B+ terminal (large wire connection). Compare to battery voltage. Voltage drop between alternator output and battery positive terminal should not exceed 0.5V. Excessive drop indicates poor connection or damaged wiring.
6. 6

   Inspect alternator belt condition and tension
   Turn engine off. Visually inspect serpentine belt for cracks, glazing, or excessive wear. Check belt tension by pressing on belt between alternator and crankshaft pulleys with moderate thumb pressure (approximately 22 lbs force). Belt should deflect no more than 1/4 inch. Loose or worn belt can cause inadequate charging even with functional alternator.
   ⚠Ensure engine is off and cool before inspecting belt
7. 7

   Check battery condition and terminals
   Inspect battery terminals for corrosion, looseness, or damage. Clean terminals if necessary with wire brush. Verify battery hold-down is secure. If charging voltage tests passed but battery goes dead frequently, perform separate battery load test to verify battery capacity. Battery should maintain at least 9.6V during 15-second load test at half the CCA rating.
8. 8

   Verify PCM for charging system codes
   If charging system voltage was abnormal during testing, check for diagnostic trouble codes using scan tool. Common codes related to charging system include P0620 (Generator Control Circuit), P0622 (Generator Field Control Circuit), and B1437 (Battery Sensor Circuit). Address any codes found per Honda service procedures.

Reassembly

1. No disassembly required for this test procedure
2. Ensure all test equipment is disconnected before driving vehicle

Verification

• Engine should start normally without hesitation
• Battery voltage with engine running should be 13.8-14.7V at idle and under load
• No charging system warning lights should be illuminated on instrument cluster
• Voltage should remain stable without significant fluctuation during electrical load changes

More procedures for this vehicle